John Deere 635 Mower-Conditioner

Studio image of 635 Mower-Conditioner

The 635 Mower-Conditioner delivers a fast, clean cut, field after field, season after season. The low-profile cutterbar stays close to the ground, allowing you to work at a flatter angle.

  • Urethane roll conditioner available
  • Cutting platform is gear-driven
  • Adjustable gauge shoes
  • Flotation tires
Key Specs:
PTO speed 1,000 rpm
1000 rpm 1-3/8 in. PTO 67-112 kW
90-150 hp
Powerline type Double-telescoping Grob spline
Standard hitch Clevis
Optional hitch Ball joint equal angle hitch
Hydraulic pressure required 13,790 kPa
2,000 psi
Cutterbar - cutting width 3.5 m
11.5 ft
Number of disks/knifes 7
14
Transport width 3.5 m
11.5 ft
Power requirements:
PTO speed 1,000 rpm
1000 rpm 1-3/8 in. PTO 67-112 kW
90-150 hp
Powerline type Double-telescoping Grob spline
Tractor equipment:
Standard hitch Clevis
Optional hitch Ball joint equal angle hitch
Rockshaft swivel hitch
Hydraulic pressure required 13,790 kPa
2,000 psi
Cutterbar:
Type John Deere
Cutting width 3.5 m
11.5 ft
Cutting height 28-98 cm
1.1-3.72 in.
Number of disks 7
Number of knives 14
Disk speed 2,650 rpm
Knife tip speed 307 km/h
191 mph
Disk drive Gear
Lubrication Hy-Gard oil
Oil reservoir capacity 8 L
8.5 U.S. qt
Cutterbar oil check Drain plug
Cutterbar angle Adjustable
Angle adjustment Mechanical or hydraulic
Cutterbar protection Shear hub
Adjustable gauge shoes Yes
Impeller conditioner:
Width 236 cm
92.7 in.
Diameter 25.4 cm
10 in.
Tines type V-tines
Number of tines 57
Number of speeds 2
Drive 3-V powerband belt and sheaves
Conditioner hood Infinite adjust, single hand crank
Rolls conditioner:
Width 236 cm
92.7 in.
Diameter 25.4 cm
10 in.
Type of material Urethane
Design Recessed cleat
Speed 664 rpm
Drive Telescoping shaft
Dimensions:
Transport width
3.5 m
11.5 ft
Transport length
6.3 m
20.6 ft
Weight, roll conditioner With urethane rool conditioner: 2,388 kg
5,264 lb
Weight, impeller conditioner 2,233 kg
4,923 lb
Standard tires Standard: 11L-15
Optional: 31x13.5L 15
General:
Are wrenches required for adjusting?